How to Apply
- Clean Surface of Bat
- Peel back a short length of protective film, keep tape clean and dry
- Begin with one complete overlap, then stretch while continuing to wrap (providing overlap for bonding)
- Cut tape at desired length, ensuring that the final wrap is completely touching itself
- One 10ft roll can wrap up to four bats*
For maximum strength, overlap about 25% of the tape when wrapping
up the bat. Pull tighter for thinner feel, tape stretches up to 300%. On
final wrap, tape should end completely on itself without touching the
bat. Bond begins to cure immediately upon contact with itself.
Repositioning after 2 minutes is not recommended.
* Total length of tape is 10 feet. Estimated 30 inches of tape
per bat. Actual amount of bats that can be wrapped
may vary depending on amount of tape used.
